DISASSEMBLY OF INSTRUMENT PARTS
5-5
LCD
Remove the front panel.
Remove the 4 screws attaching the LCD to the front panel
Keypad
Remove the front panel.
Disconnect the overlay from the overlay adaptor board.
Use a screwdriver, knife or similar to remove a corner of the
overlay from the front panel. Pull the overlay off.
Clean the surface of the front panel from all glue remainders.
Sensor cover with speed, imbalance and rotor detection
Open the lid.
Remove the front panel and flip down the main board.
Disconnect the sensor cover from the main board (X8).
Remove the rubber boot. At the bottom push it towards the
motor and pull it up.
Remove the AutoLock head from the motor.
Remove the 5 screws attaching the sensor cover to the motor.
Attach a string to the cables before pulling them through.
Remove the sensor cover.
Use the string to pull the cables of the new sensor cover
through.
Make sure the rubber boot is flush with the sensor cover after
correct installation.
Temperature sensor
Open the lid.
Remove the front panel and flip down the main board.
Disconnect the temp. sensor from the main board (X3).
Remove the rubber boot. At the bottom push it towards the
motor and pull it up.
Attach a string to the cable before pulling it through.
Remove the sensor from the rubber boot
Use the string to pull the cable of the new sensor through.