DISASSEMBLY OF INSTRUMENT PARTS
5-2
Disassembly of mechanical parts
Front Panel
Open the lid, switch off the unit and pull out the mains plug
Remove the 2 screws on top of the front panel
Pull the front panel up and lift it off.
Disconnect wiring from display and overlay adaptor board
Back panel
Switch off the unit and pull out the mains plug.
Remove the 7 screws attaching the back panel to the casing.
Tilt the panel down and unplug the cables.
Gas lid stay
Open the lid
Remove the cotter pin from the joint block with help of a striker
pin and a hammer.
Unscrew the gas lid stay from its bottom holder counter
clockwise.
Take out the gas lid stay to the top.
Lid
Open the lid, switch off the unit and pull out the mains plug
Remove gas lid stay from top joint block
Remove the 6 screws attaching the lid hinge to the main frame.
When reassembling the lid take care that the lid hook fits the
casing hole centric.
The lid hook must be adjusted to a length of 46.5mm (+0.5) (tip to
metal sheet).
46.5 - 47mm