Wind The Thread On The Bobbin; Winding The Bobbin - John Lewis JL 300 Manual

Winding the Bobbin

Ordinary Spool
Small Spool
Horizontal Spool Pin
Lift up the spool pin. Place the spool of thread on the
spool pin with the thread coming off the spool as
shown.
Attach the large spool holder pressing it firmly
against the thread spool.
* The small spool holder is used with narrow or
small thread spools.

Wind the thread on the bobbin

w
q
Place a spool on the spool pin.
The thread end should come off
as shown.
w
Guide the thread around the
thread guide.
Removing the Bobbin
Gently slide the hook cover plate release button to
the right, and remove the cover plate.
Lift out the bobbin.
q
e r t
e
e
Thread through the
hole in the bobbin
from the inside to
the outside.
Put the bobbin on
the bobbin winder
spindle
Additional Spool Pin
The additional spool pin is used to wind extra
bobbins without unthreading the machine.
To use, insert the additional spool pin in the hole.
Place the felt and the spool on the pin.
r
r
Push it to the right. With the free
end of the thread held in your
hand, depress the foot control.
Stop the machine when the bobbin
has made a few turns, and cut the
thread close to the hole in the
bobbin.
* Stop running the machine
without fail in advance when
moving the bobbin winder spindle.
t
t
Depress the foot control
again. When the bobbin is
fully wound, it will stop
automatically.
Return the bobbin winder
to its original position by
moving the spindle to the
left, and cut the thread as
shown.
9