Suzuki NEXA BALENO Owner's Manual & Service Booklet page 394

EMERGENCY SERVICE
(2)
(3)
(3)
5) Clean any mud or dirt off from the sur-
face of the wheel (1), hub (2), thread
part (3) and surface of the wheel nuts
(4) with a clean cloth. Clean the hub
carefully; it may be hot from driving.
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
10-11
(1)
(4)
(5)
Tightening torque for wheel nuts
(1)
100 Nm (10.2 kg-m, 74.0 lb-ft)
7) Lower the jack and fully tighten the nuts
with a wrench in numerical order as
shown in the illustration.
(4)
84S08170
Use genuine wheel nuts and tighten
them to the specified torque as soon
as possible after changing wheels.
Incorrect wheel nuts or improperly
tightened wheel nuts may come
loose or fall off, which can result in
an accident. If you do not have a
torque wrench, have the wheel nut
torque checked by an authorized
Maruti Suzuki authorised workshop.
Loosen
Tighten
68PM08010
WARNING
(1)
Return the spare tyre back into the lug-
gage compartment in the reverse order of
removal and tighten its bolt (1) clockwise
as shown in the above illustration.
NOTICE
Make sure that the spare tyre is fixed
securely on the floor. Loosely fixed
tyre may cause noise during driving
and damage paint on vehicle body.
68PM08001