Suzuki NEXA BALENO Owner's Manual & Service Booklet page 352

INSPECTION AND MAINTENANCE
Parking Brake
"b"
Ratchet tooth specification "b":
4th – 9th
Lever pull force (1):
200 N (20 kg)
Check the parking brake for proper adjust-
ment by counting the number of clicks
made by the ratchet teeth as you slowly
pull up on the parking brake lever to the
point of full engagement. The parking
brake lever should stop between the speci-
fied ratchet teeth and the rear wheels
should be securely locked. If the parking
brake is not properly adjusted or the
brakes drag is suspected even after the
lever has been fully released, have the
parking brake inspected and/or adjusted by
a Maruti Suzuki authorised workshop.
9-17
Brake Discs and Brake Drums
Brake disc
55T090270
Brake location
Front wheels
"a" "a"
55T090650
Minimum thickness "a"
18.0 mm
Brake drum
Maximum inner
Brake location
diameter "b"
Rear wheels 202 mm
If the measured thickness or inner diame-
ter of the most worn part falls below or
exceeds the value indicated above, the
parts should be replaced with a new one.
The measurement involves disassembling
each brake and requires the use of a
micrometer or caliper, which must be done
according to the instructions described in
the relevant service manual or available
from the relevant repair information site.
"b"
55T090660