Suzuki NEXA BALENO Owner's Manual & Service Booklet page 156

INSTRUMENT CLUSTER
Driving time
(11) Driving time
Driving time from previous reset is shown.
To reset the driving time, push and hold the
indicator selector knob (3) for about 2 sec-
onds when the display indicates a driving
time. The display shows "---" and then indi-
cates a new driving time after driving for a
short time.
NOTE:
• Disconnection of the lead-acid battery
negative (-) terminal will reset the indica-
tion of the driving time.
• The indicated maximum value of driving
time is 99:59:59. No more than this
value will be indicated on the display
until you reset the driving time.
4-23
Total idling stop time and total idling
fuel saved (if equipped)
(11)
52RM21120
(12) Total idling stop time
(13) Total idling fuel saved
The display shows the total length (in
hours, minutes and seconds) of engine
stopping time and the total amount (in milli-
liters) of fuel conservation by ENG A-
STOP system since the indication was
reset.
• To reset the total idling stop time and the
total idling fuel saved, push and hold the
indicator selector knob (3) for a while
when the display shows the total idling
stop time and the total idling fuel saved.
NOTE:
• The indicated maximum value of the
total idling stop time is 99:59:59 and this
value is fixed until it is reset.
• When you reconnect the negative (–)
terminal to the lead-acid battery, the
value of the total idling stop time and the
total idling fuel saved will be reset.
Clock and date
Date and time are shown. For the setting
procedure, refer to "Setting mode" in this
(12)
section.
Motion (if equipped)
(13)
(14)
52RM217
his indicates how the center of gravity is
moved while driving.
G (acceleration of gravity) position applied
to the vehicle body while driving is shown
by a globe (14).
When the vehicle is stopped, historical
data of G positions applied to the vehicle
body during the driving is shown as a
graph (15).
(15)
52RM218