Suzuki NEXA BALENO Owner's Manual & Service Booklet page 215

Table of Contents

Advertisement

WARNING
• When stopping, for example, at a
traffic light, be sure to depress the
brake pedal firmly. For your safety,
apply the parking brake, too, when
stopping on a hill.
• When racing the engine, make sure
that the gear is in the "N" position
by checking the gear position indi-
cator. If the accelerator is operated
with the gear in any other position,
the vehicle may move resulting in
an unexpected accident.
• Do not leave your vehicle unat-
tended while the engine is running.
• When leaving the vehicle, stop the
engine and park the vehicle with a
gear engaged. If you need to leave
the vehicle with the engine running,
apply the parking brakes firmly,
and shift the gearshift lever to the
"N" position. Otherwise, the vehi-
cle may move unexpectedly and
may cause an accident.
NOTICE
• On a slope, never hold the vehicle
at a stop using only the accelerator
pedal or the creeping function. If
you perform this operation for a
certain period of time, a warning
buzzer will sound, and in some
cases the engine will stall. This can
also cause excessive damage to
the clutch.
• If the gearshift lever is operated
more than necessary, the system
may not allow operation of the
gearshift lever for a certain period
of time, and the gear may not be
shifted appropriately. Therefore, do
not operate the gearshift lever if not
necessary.
OPERATING YOUR VEHICLE
Parking
Unlike an automatic transmission, Auto
Gear Shift does not have a parking posi-
tion. The vehicle can be parked with the
gearshift lever at "D" or "R" position.
Remember, even though the transmission
is in gear, you must set the parking brake
firmly. Park the vehicle with a gear
engaged.
1) Apply the parking brake firmly.
2) While depressing the brake pedal, shift
the gearshift lever to the "R" position on
a downhill slope, and to the 1st position
in the drive (D) mode or the "M" position
in the manual (M) mode on an uphill
slope and confirm the gear position by
checking the gear position indicator.
3) Stop the engine.
4) In the case of uphill/downhill slope,
release the parking brake and brake
pedal slowly in order to check the gear
is engaged.
5) After check the vehicle stopped by the
gear engaged, Apply the parking brake
and the brake pedal firmly again.
6) Get out of the vehicle and put chocks
under the wheels.
When you return to your vehicle, you must
remember to remove the wheel chocks.
NOTE:
• After the engine is stopped, the gear in
the transmission does not change even
if you shift the gearshift lever in any posi-
tion. Always shift the gearshift lever
before stop the engine.
5-30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents