Suzuki NEXA BALENO Owner's Manual & Service Booklet page 223

Actuation Conditions for ENG
A-STOP System
Standby conditions
When all of the following conditions are
met while the vehicle is traveling, ENG A-
STOP system will be permitted:
• The engine is started with the hood com-
pletely closed.
• The hood is completely closed.
• The ENG A-STOP OFF switch has not
been pressed to deactivate the ENG A-
STOP system.
• The battery is fully charged and the tem-
perature inside the battery is within the
specified range (#1).
• The engine has warmed up and the
engine coolant temperature is within the
specified range.
• The driver is wearing seat belts.
• The driver's door is completely closed.
• No electronically controlled
besides the ENG A-STOP system is
issuing a signal to inhibit stopping of the
engine (#2).
• For the vehicle equipped with automatic
heating and air conditioning system, the
temperatures at air-conditioner outlets
are sufficiently low in the cooling mode
or sufficiently high in the heating mode.
• For the vehicle equipped with automatic
heating and air conditioning system, the
defroster is turned off.
• The negative pressure of the brake
booster is normal.
• The ABS or ESP
been activated during one driving cycle
(a) from the engine start to the vehicle
start and stop.
• The gearshift lever is in "D" or "N" (for
auto gearshift vehicle).
#1 If the vehicle has not been in use for an
extended period of time or the audio or
other electrical component was used
system for an extended period of time while the
engine was stopped, the battery may
have discharged and it may take some
time before the standby mode is
achieved.
#2 If any of the warning and indicator lights
affecting the ENG A-STOP system
come on, the engine will not be stopped
automatically.
Automatic engine stop conditions
When all of the following conditions are
(a) (a)
met under the standby conditions, the
engine will stop automatically after the
vehicle has stopped:
• The gearshift lever is in "N" (Neutral)
• The clutch pedal is released (for manual
55RH03001 • Engine auto stop function will be ready
®
(if equipped) has not
• The vehicle has stopped.
• The accelerator pedal is not depressed.
• The vehicle is not stopped on a steep hill
• The gearshift lever is in "D" or "N" posi-
• The brake pedal is depressed appropri-
OPERATING YOUR VEHICLE
position (for manual transmission vehi-
cle).
transmission vehicle).
once the vehicle runs at a speed
exceeding 6km/h after restart of the
engine.
(for auto gear shift vehicle).
tion (for auto gearshift vehicle).
ately (for auto gearshift vehicle).
NOTICE
For Auto Gear Shift vehicle, the ENG
A-STOP system will not operate, if
the brake pedal is depressed weakly
or very strongly.
5-38