Suzuki NEXA BALENO Owner's Manual & Service Booklet page 141

Average fuel consumption
If you selected average fuel consumption
the last time you drove the vehicle, the dis-
play shows the last value of average fuel
consumption from previous driving when
the ignition switch is turned to "ON" posi-
tion or the engine switch is pressed to
change the ignition mode to ON. Unless
you reset the value of average fuel con-
sumption, the display indicates the value of
average fuel consumption which includes
average fuel consumption during previous
driving.
To reset the average fuel consumption,
push and hold the indicator selector knob
(2) for a while when the display shows the
average fuel consumption.
NOTE:
When you reset the indication or reconnect
the negative (–) terminal to the lead-acid
battery, the value of average fuel con-
sumption will be shown after driving for a
while.
(For "L/100km" or "km/L" setting)
To change the unit of average fuel con-
sumption, while pushing and holding the
trip meter selector knob (1), turn the indica-
tor selector knob (2).
NOTE:
When you change the units that average
fuel consumption is displayed in, the
instantaneous fuel consumption units will
be changed automatically.
Driving range
If you selected driving range the last time
you drove the vehicle, the display indicates
"---" for a few seconds and then indicates
the current driving range when the ignition
switch is turned to "ON" position or the
engine switch is pressed to change the
ignition mode to ON.
The driving range shown in the display is
an indicative unit of the approximate dis-
tance you can drive until the fuel gauge
indicates "E", based on current driving con-
ditions and current fuel level in the fuel
tank.
When the low fuel warning light comes on,
the display "---" will appear.
(Initial
If the low fuel warning light comes on, fill
setting)
the fuel tank immediately regardless of the
value of driving range shown in the display.
When you refuel, the driving range is
updated. However, if you only add a small
amount of fuel, the correct value will not be
displayed.
NOTE:
• If you refuel when the ignition switch is in
55T040240
"ON" position or the ignition mode is ON,
the driving range may not indicate the
correct value.
• When you reconnect the negative (–)
terminal to the lead-acid battery, the
value of driving range will be shown after
driving for a while.
•
If there are substantial changes in the
driving pattern or vehicle usage, the dis-
played range may vary significantly.
Fuel Gauge
The display (F) shows the fuel gauge.
Refer to "Fuel gauge" in this section.
INSTRUMENT CLUSTER
4-8