Suzuki NEXA BALENO Owner's Manual & Service Booklet page 154

INSTRUMENT CLUSTER
NOTE:
When you reconnect the negative (–) ter-
minal to the lead-acid battery, the value of
average fuel consumption will be shown
after driving for a period of time.
You can select the timing to reset the value
of average fuel consumption by one of the
following three methods;
• Reset after refuel: the value of average
fuel consumption will be reset automati-
cally by refueling.
• Reset with trip meter A: the value of
average fuel consumption will be reset
automatically by resetting trip meter A.
• Reset manually: the value of average
fuel consumption will be reset by push-
ing and holding the indicator selector
knob (3) when the display indicates the
average fuel consumption.
To change the timing to reset the value of
average fuel consumption, refer to "Setting
mode" in this section.
NOTE:
If you add only a small amount of fuel
when you select "Reset after refuel", the
average fuel consumption value may not
be reset.
4-21
(5-minute average fuel consumption)
(6) 5-minute average fuel consumption
(1-driving cycle average fuel consumption)
(7) 1-driving cycle average fuel con-
sumption
You can check transition of average fuel
consumption every 5 minutes from 15 min-
utes before up to now. Also, you can check
transition of average fuel consumption the
past 3 driving cycles. Time indication and
driving cycle indication can be changed.
For details, refer to "Setting mode" in this
section.
Driving range
(6)
68PM00282
(8) Driving range
If you selected driving range the last time
(7)
you drove the vehicle, the display indicates
"---" for a few seconds and then indicates
the current driving range when the ignition
switch is turned to "ON" position or the
56RM02018
engine switch is pressed to change the
ignition mode to ON.
(8)
52RM21090