Culligan ClearLink PRO Installation, Operation, And Service Instructions With Parts Lists page 20

D
20 Culligan ClearLink
®
Figure 3. Battery Box
Figure 4. Connection Port
4.
5.
Figure 5. Test Leak Sensor
3. Install four D batteries
(not included) into the battery
box and plug into the jack on
the bottom of the control box.
NOTE The control box will beep
and flash the power light
when powering up.
NOTE AC adapter (01029455)
can also be used where
a non-switch-controlled
outlet is available.
NOTE The Aquasential
ClearLink PRO receives
its power from the
Aquasential Smart
RO. See Figure 4 for
connection point.
Place a damp paper towel to the pins.
This should cause the leak sensor light on
the control box (page 19) to flash, the
unit to beep and the Culligan Connect App
(if setup) to notify the user of the error.
Dry pins and place at the lowest point in the
cabinet or under the ClearLink Control Box.
20 Cat. No. 01033136