Culligan ClearLink PRO Installation, Operation, And Service Instructions With Parts Lists page 14

NOTE Steps 6 through 8 are only for RO installations using an air gap.
NOTE If your filtration system is not an RO, skip to System Startup.
NOTE Install the drain connection to the drain plumbing according to the manual provided with your RO system.
NOTE Check and adhere to local plumbing codes for Air Gap installation.
14 Culligan ClearLink
®
Outlet to ClearLink
top side port
Inlet from ClearLink
bottom side port
Outlet to ClearLink
top side port
Outlet to tank
Inlet from ClearLink
AIR GAP
bottom side port
5. Connect the product water outlet
on the RO/Filter system to the port
marked "RO/Filter ►." Wet the end of
the plastic tubing with water and push
it into the quick connect fitting adapter
until it stops.
NOTE This is the line that would normally
go to your dedicated faucet.
NOTE Connect the tank and/or post
filter in this line if required for
your filter/RO system.
6. Mount the air gap device as near to counter top
as possible and in a vertical orientation.
6a. The provided installation bracket can be used
in order to assist in mounting the air gap as
high as possible.
To use: Attach the air gap to the bracket using
a single screw. Raise the assembly as high as
possible and secure to the cabinet using the
bracket's lower mounting points.
WARNING! Install the air gap
WARNING! Failure to mount
14
as high as possible
using air gap
installation bracket.
the air gap device
vertically will cause
it to leak water.
Cat. No. 01033136