Culligan ClearLink PRO Installation, Operation, And Service Instructions With Parts Lists page 17

Flow Switch Wiring
NOTE The standard length of the flow switch wire is 3'.
If needed, a 40' wire extension is available separately.
10. Reinsert screws.
9. Reinsert the
back cover
7. Reinsert slider.
6. Reinsert the manifold
with circuit board.
Cat. No. 01033136
1. Remove Screws
2. Remove the back cover.
3. Remove slider.
8. Lay the wire into the groove.
5. Push on orange tab,
insert wire, then let
go of orange tab.
NOTE Gently pull on wires
to confirm that they
are fully inserted.
4. Remove manifold
with PCB.
Installation 17