Grandstream Networks GXV34 0 Series Manual page 59

Defines the VLAN Identifier of the Layer 2 frame for PC port. This adds the VLAN tag value on the target
address received from the LAN port of the phone then sends the value to the device connected to the PC
port.
PC Port
VLAN Tag
Note: VLAN tag value on the device connected to the PC port should be the same as the VLAN tag value
assigned to the PC port here.
PC Port
Priority Determines the Priority Code Point within a Layer 2 frame header for PC port.
Value
Proxy
Configures the HTTP/HTTPS proxy URI of the network. Some of networks requires going through a proxy
HTTP/HTTPS
to access to the Internet.
Proxy
The default setting is keeping this field blank.
Hostname
Configures the HTTP/HTTPS proxy port number of the network. Some of networks requires going through
HTTP/HTTPS
a proxy to access to the Internet.
Proxy Port
The default setting is keeping this field blank.
Defines the specific URI that the phone can directly access to without HTTP/HTTPS proxy. If it is filled, the
Bypass Proxy
phone will bypass the proxy to send the packets to the specific URI.
For
The default setting is filed blank.
Remote
Control
Indicates whether CSTA Control feature is enabled. Change of this configuration will need the system
CSTA
reboot to make it take effect.
Control
Action URI
Configures whether the phone is enabled to receive and handle Action URI request.
Support
Remote Configures whether the phone is enabled to pop up allow remote control window. If set to "Yes", when the
Control Pop remote console is connected to the phone, the phone will pop up a window to allow remote control or not.
up Window If set to "No", once the remote console successfully connect s to the phone, it can directly control the
Support phone remotely.
Action URI List of allowed IP addresses from which the phone receives the Action URI. If input "any", any remote
Allow IP List console can access this phone.
Network Settings/SNMP Settings
Enable SNMP Configures whether to enable SNMP.
Version Selects SNMP version from the drop-down list.
Port Configures the port for SNMP.
Username Configures username for SNMPv3.
Security Level Selects security level for SNMPv3.
Trap Version Selects trap version of SNMP trap receiver.
Trap IP Version Configures IP address of SNMP trap receiver.
Trap Port Configures the port of SNMP trap receiver.
Table 34: Network Settings/Advanced Network Settings