Grandstream Networks GXV34 0 Series Manual page 43

Mute on Answer When enabled, phone will mute the incoming intercom call based on Call-Info/Alert Info Headers.
Intercom Call Default is disabled.
Transfer on 3-way Transfers conference from hosted party when hang up, thus other parties can continue the
Conference Hang up conference without interruption. Default is unchecked.
Treats "#" as the "Send" (or "Dial") key when set to "Yes". If set to "No", this "#" key can be included
Use # as Dial Key as part of the dialed number or it will be used as redial key when the input area has no number
(please make sure the dial plan is properly configured to allow dialing # out). Default is "Yes".
Allows users to configure the "#" key as the "Redial" key. If set to "Yes", the "#" key will immediately
Use # as Redial Key redial the last call. In this case, this key is essentially equivalent to the "Redial" key. If set to "No", the
"#" key is treated as part of the dialed string. Default is "Yes".
Configures the feature code to enable the DND (Do Not Disturb) feature for this account. If it is
DND Call Feature On
configured, the phone will dial the feature code automatically when the DND feature is enabled.
Configures the feature code to disable the DND (Do Not Disturb) feature for this account. If it is
DND Call Feature Off
configured, the phone will dial the feature code automatically when the DND feature is disabled.
Determines the expiration timer (in seconds) for no key entry. The dialed digit will be sent out if no
No Key Entry Timeout
other digits entered within the set period. The default value is 4 seconds. The valid range is 1 - 15.
(s)
This feature does not work if the dialer page is entered via the Account Widget on the phone.
Defines the expiration timer (in seconds) for the rings with no answer.
Ring Timeout (s)
The default setting is 60. The valid range is from 10 to 300.
Sets the phone system to use the target's Contact header tag to the Refer-To header in the SIP
Refer-To Use Target
REFER message during an attended transfer.
Contact
The default setting is "No".
RFC2543 Hold If yes, c=0.0.0.0 will be used in INVITE SDP for hold.
Sets the Call Forwarding feature for this account.
● None: Disable call forwarding feature.
● Unconditional: Set to forward all calls to a specified account.
● Time based: Set the call forwarding rule based on time. The system can forward incoming calls
● Others: Set the call forwarding rule based on following account status.
Call Forward Type
1. Forward when Busy: the call will be forward to number set under "Busy To" when the account
2. Forward when No Answer: The call will be forwarded to the number set under "No Answer To"
3. Forward when DND: When the phone is on DND mode the call will be forwarded to number
Dial Plan Prefix Configures the digits prepended to the dialed number.
Call Forwarding
to the accounts of In Time Forward to and Out Time Forward to.
is busy.
after the configured timeout. (range 1- 120s)
configured under "DND To".
Dial Plan