Grandstream Networks GXV34 0 Series Manual page 55

Selects the Internet protocol to use. When both IPv4 and IPv6 are enabled, phone will attempt to use
IP Mode
the preferred protocol first and switches to the other protocol if there are any issues.
Different
Networks for Configures whether to set up different networks for the phone data and the call. If set to "Yes", you
Data and VoIP need to configure the data network and VoIP network respectively.
Calls
IPV4
Configures the appropriate network settings on the phone. Users could select from "DHCP", "Static IP"
IPv4 Address or "PPPoE"(Point-to-point Protocol over Ethernet).
Type
By default, it is set to "DHCP".
Selects the DHCP Option VLAN mode. When set to "DHCP Option 132 and DHCP option 133", the
phone will get DHCP option 132 and 133 as VLAN ID and VLAN priority. When set to "Encapsulated in
DHCP Option 43", the phone will get values from Option 43 which encapsulate VLAN ID and VLAN
DHCP VLAN
Override priority.
Note: Please make sure the "Allow DHCP Option 43 and Option 66 to Override Server" setting under
maintenance
DHCP Host name Sets the name of the client in the DHCP request. It is optional but may be required by some Internet
(Option 12) Service Providers.
Vendor Class ID Configures the vendor class ID header in the DHCP request.
(Option 60) The default setting is Grandstream GXV3480.
IP Address Defines the phone's static IP address if the static IP is used.
Subnet Mask Determines the network's subnet mask if the static IP is used.
Default Gateway Defines the network's gateway address if the static IP is used.
DNS Server 1 Configures the primary DNS IP address if the static IP is used.
DNS Server 2 Configures the secondary DNS IP address if the static IP is used.
PPPoE Account ID Configures the PPPoE account ID if the PPPoE is used.
PPPoE Password Sets the PPPoE password if the PPPoE is used.
Assigns the VLAN Tag of the Layer 2 QoS packets for Ethernet.
Layer 2 QoS
The Default value is 0
802.1Q/VLAN Tag
(Ethernet) for Note: When Different Networks for Data and VoIP Calls set to Yes, then this option will be applied
Data for Data.
Assigns the priority value of the Layer 2 QoS packets for Ethernet.
Layer 2 QoS
The Default value is 0.
802.1p Priority
Value (Ethernet)
Note: When Different Networks for Data and VoIP Calls set to Yes, then this option will be applied
for Data for Data.
IPV6
Configures the appropriate network settings on the phone.
IPv6 Address
Users could select from "Auto-configured" or "Statically configured".
Type
Configures whether to enable IPv6 privacy address. If enabled, the device will carry multiple IPv6
Enable IPv6
addresses. Note: This may cause problems with some servers such as BroadSoft and result in account
Privacy Address
registration failure (invalid or no response).
Static IPv6
The static IPv6 address when static IPv6 is used.
Address
IPv6 Static
The static gateway when static IPv6 is used.
Gateway
����
upgrade is checked. The default setting is " Encapsulated in DHCP Option 43 ".