Introduction; Kit Contents - ZiLOG Z8 Encore! XP F64 Series User Manual

Introduction

The Zilog Z8 Encore! XP
vides Z8 Encore! XP
event system for program debugging using ZDS II development tools.
This user manual tells you how to do the following:
1. Install ZDS II software.
2. Configure the Z8 Encore! XP
3. Connect the Z8 Encore! XP
4. Run a demonstration program to verify proper operation and illustrate

Kit Contents

•
•
•
•
•
•
•
UM016804-0208
®
F64xx Series MCU emulation with a trace and
your PC.
using a Z8 Encore! XP
basic operation of the trace and event system.
One (1) Z8 Encore! XP
One (1) DB9-to-DB9 serial I/O cable.
One (1) CAT-5 crossover cable.
One (1) 40-pin PDIP, 44-pin LQFP, 44-pin PLCC, 64-pin LQFP, 68-
pin PLCC, or 80-pin QFP package adapter (depending on the emula-
tor model you ordered).
One (1) target POD with ribbon cables to connect the Z8 Encore!
®
XP F64xx Series ICE to the package adapter that came with your
kit. (To obtain adapters for other Z8 Encore! XP
packages, refer to "Adapter Ordering Information" on page 21.)
Two (2) 5V AC power supply and adapters
One (1) ZDS II Installation CD-ROM
®
F64xx Series In-Circuit Emulator (ICE) pro-
®
F64xx Series ICE for connection to
®
F64xx Series ICE to a target board
®
F64xx Series MCU package adapter.
®
F64xx Series In-Circuit Emulator.
In-Circuit Emulator
User Manual
®
F64xx Series MCU
1