Table of Contents
Advertisement
DB9 connector
Figure 2. Z8 Encore! XP
4. Connect the ribbon cables from the target POD to connectors J2 and
5. Plug the target POD into the package adapter installed on the target
6. Connect a 5 VDC power supply to the Z8 Encore! XP
7. Connect a 5 VDC power supply to the Z8 Encore! development
UM016804-0208
Link
LAN
Ethernet
(RJ-45)
J10 on the Z8 Encore! XP
Figure
4.)
board.
ICE. The ICE Run LED should illuminate (see
power LED fails to illuminate, or if the ICE Fail LED either blinks
continuously or fails to extinguish after 15 seconds, there is a problem
with the unit. Contact Zilog support at
for a replacement unit.
board.
Reset
USB
(unused)
Switch
®
F64xx Series ICE Rear Panel
®
F64xx Series ICE. (See
http://www.zilog.com/
In-Circuit Emulator
User Manual
3.3 VDC OK
Ext
1.8 VDC Ok
Pwr
In
Figure 3
and
®
F64xx Series
Figure
5). If either
4
Advertisement
Table of Contents
Need help?
Do you have a question about the Z8 Encore! XP F64 Series and is the answer not in the manual?