Table of Contents
Advertisement
J11 and J14
Figure 5. Z8 Encore! XP
Configure the Hardware
Configuring the Z8 Encore! XP
emulator jumper options and setting up Ethernet communications
between the emulator and your PC.
Setting Jumpers on the Z8 Encore! XP
There is one jumper on the Z8 Encore! XP
J12 allows you to select whether the emulator Watch-Dog Timer uses the
32-kHz internal oscillator or is programmable using the settings in ZDS
II.
Table 2. Jumper J12 Settings on the Z8 Encore! XP
Setting Up Ethernet Communications
The default IP address and subnet mask of the Z8 Encore! XP
Series ICE are 192.168.1.50 and 255.255.255.0, respectively. To enable
communication between the PC running ZDSII and the Z8 Encore! XP
UM016804-0208
J10 and J2
Watch-Dog Timer...
uses the 32-kHz internal oscillator
not implemented
®
F64xx Series ICE Front-Panel
®
F64xx Series ICE consists of selecting
®
®
F64xx Series ICE
Jumper Position
1 - 2 (default)
3 - 4
In-Circuit Emulator
User Manual
ICE Run
ICE Fail
J12
®
F64xx Series ICE
F64xx Series ICE. Jumper
®
F64xx
6
®
Advertisement
Table of Contents
