Table of Contents
Advertisement
2
2.5 Adjusting the Levelling Pads
2-4
Figure 2-2
Moving the Server Safely Down the Ramps
After moving the cabinet to its operating location, adjust the levelling pads as
described below.
1. Take off the rear screen by removing the two screws shown in Figure 2-3.
2. Remove the levelling wrench by unlocking the plastic strap that holds it
to the inside of the server cabinet.
Do not cut the strap. Press the plastic tab to unlock the strap around the
*wrench, then slide part of the strap through the lock to loosen the wrench.
3. Extend the stabilizer bar fully from the bottom of the cabinet.
See Figure 2-4.
4. Screw the two stabilizer bar levelling pads down until they are 1/8- to
1/4-inch (three to six millimeters) above the floor.
Make sure both pads are at equal heights above the floor. This clearance
allows an extended stabilizer bar to stop the cabinet if it should begin to tilt.
SPARCcenter™ 2000/2000E Installation Manual—June 1996
Advertisement
Table of Contents
