Table of Contents
Advertisement
3.3 Precautions for JumpStart Automatic Installation
!
Figure 3-5
Example of Network Cable
For 10Base-T Ethernet, the default interface port is on a Fast Single Ended
SCSI/Buffered Ethernet (FSBE/S) card in SBus slot 3 of the system board in
card cage slot 0.
2. Plug the network cable into the SBus network port.
3. Route the cable down along the right mounting rail of the chassis.
Use tie wraps to secure the cable to the rail.
This system is able to use the JumpStart™ automatic installation feature that is
described in installation documents for Solaris® software. The software that
enables this feature is present on a hard disk in your system.
Caution – JumpStart may incorrectly install the system as a stand-alone
workstation. You should prevent JumpStart automatic installation from
proceeding if the appropriate server-specific configuration information is not
in place. Information about the JumpStart feature is on a card titled "JumpStart
Installation Instructions" that is provided with the system documentation.
If JumpStart completes the installation incorrectly, you most likely need to
reinstall Solaris 2.X manually.
JumpStart will run only when the system is powered on for the first time.
To prevent JumpStart installation from occurring unintentionally:
•
Do not connect the system to a network when you power it on initially.
•
Do not place a Solaris release CD-ROM in a drive when you first power on
the machine.
Cabling the System
3
3-5
Advertisement
Table of Contents
Need help?
Do you have a question about the SPARCcenter 2000 and is the answer not in the manual?