Table of Contents
Advertisement
2
2-2
Note – Any unpacking instructions printed on the outside of the shipping
carton take precedence over instructions in this section.
1. Cut the plastic or metal straps that are around the shipping container and
lift off the corrugated top.
If you cannot store the shipping materials for future shipments, please
recycle or dispose of the materials properly. Your local recycling authority
can supply specific information.
2. Remove the sides of the container.
The container is held together by six plastic clips. To unlock a clip, press the
two inner tabs together and pull out the entire clip.
3. Remove inner packing materials from the top and corners of the cabinet.
4. At the front of the pallet, lift the Velcro™ strip at each end of the wooden
bar to detach the bar, then set it aside.
5. Slide out the two wooden ramps from under the cabinet.
6. Attach the wooden ramps to the pallet using the Velcro strip that is
attached to each ramp.
Ensure both wheel guides (wooden strips) are to the outside. See Figure 2-1.
7. You are ready to move the cabinet, but first read the two "Caution"
messages in the next section.
SPARCcenter™ 2000/2000E Installation Manual—June 1996
Advertisement
Table of Contents
