Time Code Operation; Displaying Time Code - JVC GY-DV5100U User Manual

10. TIME CODE OPERATION

The GY-DV5100 records SMPTE-standard time codes and user's bits. In the play mode or the record mode, the reproduced time
codes or user's bits are shown on the LCD monitor or in the viewfinder.
● Time code data cannot be output through the unit's connectors.

10-1 Displaying Time Code

OPEN
LCD BRIGHT DISPLAY
AUDIO
LEVEL PULL
OPEN
FRONT
REAR
CH-1 CH-2
CH-1 CH-2
AUDIO IN
AUDIO SELECT
CH-1 CH-2
AUTO
MANUAL
Time code indication
00:00:00:00
STBY 01/02/03 01:23:45
Status 1 screen
COUNTER switch
LCD BRIGHT DISPLAY
MONITOR
SELECT
COUNTER
CH-1
FRONT
MIX TC
CH-2 REAR
UB
AUDIO
CH-1 CH-2
CH-1 CH-2
LEVEL AUDIO IN
REAR
AUDIO SELECT
AUDIO IN
FRONT MIC +48V
TC GENE.
CH-1 CH-2 CH-1 CH-2
LINE AUTO PRST FREE
ON OFF
REC
MIC MANUAL
+48V
REGEN
Example
Time code indication
00:00:00:00
Non-drop frame (:)
Drop frame (.)
User's bits indication
FF EE DD 20
The time codes or user's bits can be shown on the LCD monitor
or in the viewfinder during playback and recording as follows.
(Status screen)
Setting
1.
Set the TC/UB item on the LCD/VF (2/2) menu screen to
ON.
● Time codes or user's bit data are displayed on the Status
screen.
2.
Whether time codes or user's bit data should be displayed
is selected with the COUNTER switch inside the cover on
the side.
TC : Time codes are displayed.
The symbol between the seconds and the frame
differs with the framing mode. (Colon or dot)
UB : User's bit data is displayed.
Time code entered from the DV connector
■ Time code entered from the DV connector
Pressing the STOP button for 1 second in the EJECT or stop
mode displays the time code data or user's bit data input
from the DV terminal on the Status screen.
DTCG : The time code data from the DV terminal
DUBG : The user's bit data from the DV terminal
To return to display of the original time code or user's bit,
press the STOP button.
(Display of the normal time code or user's bit is also restored
by performing VTR operation.)
MEMO:
● The time code and user's bit input from the DV terminal
are not recorded. The data generated by the camera's
time code generator is recorded.
● To maintain the continuity of time code data, use with
the TC GENE. switch set to REGEN mode when
recording input signal from the DV terminal.
67