JVC GY-DV5100U User Manual page 36

4. POWER SUPPLY
4-2 Battery Pack Operation (Optional) (Cont'd)
Attaching and Detaching an Anton-Bauer Battery Pack
Cassette cover side panel
Release
lever
Side panel
with display
Attaching the NP-1B type Battery
To use the NP-1 type battery, remove the Anton-Bauer Battery holder and attach the NP-1 type battery holder to the
camera. Use the following battery case.
Battery case: SCV2978-002
For details, please consult your JVC authorized dealer.
Detaching the Anton-Bauer Battery Holder and Attaching the Battery Case
Be careful of pins.
2.
1.
1.
Anton-Bauer
Battery holder
4.
3.
Black screws A
36
Guide pins
Battery pack
Guide holes
(x3)
AUDIO
LEVEL
CH-2
Connector
Compartment
Attaching the Battery Pack
1.
Align the 3 guide pins of the battery pack with
the guide holes on the battery holder, and push
straight to insert the battery pack.
The battery cannot be attached properly if the
Release lever
guide pins are not inserted straight.
2.
Slide the battery pack toward the side panel
where the cassette cover is located until it clicks.
Now the battery pack has been attached.
OPEN
LCD BRIGHT DISPLAY
Detaching the Battery Pack
PULL
OPEN
FRONT
REAR
CH-1 CH-2
AUDIO INPUT
AUDIO SELECT
CH-1 CH-2
AUTO
MANUAL
■ While pushing the release lever, slide the battery
pack toward the side panel where the LCD display
Battery
is located, then pull the battery pack outward to
remove.
CAUTION:
The Anton-Bauer Battery Holder has pin connectors. Be
careful not to touch these pin terminals when attaching or
removing the battery and holder. Doing so may cause injury.
1.
Remove the four battery holder anchoring screws.
2.
Disconnect the connector and battery holder connector
coming out of the camera.
3.
Remove the two black screws A for the battery case.
4.
Remove the bottom portion of the battery case cover
downwards.