Appendix A - Specifications - ADC HiGain H2TU-C-202 Manual

LTPH-TP-1005-02, Issue 2
A
PPENDIX
Power
Line Voltage
CO Supply
Electrical Protection
Fusing
Environmental
Operating Temperature
Operating Humidity
Physical
Height
Width
Depth
Weight
Mounting
HDSL2
Line Code
Transmission
Media
Output
Line Impedance
Maximum Provisioning Loss
Start-up Time
DSX-1
DSX-1 Line Impedance
Line Rate
Line Format
Frame Format
DSX-1 Pulse Output
DSX-1 Input Level
System
One-way DS1 Delay
Wander (Looped)
Wideband Jitter (Looped)
Narrowband Jitter (Looped)
H2TU-C-202 List 3E
A - S
PECIFICATIONS
0, -185 Vdc
-48 Vdc nominal (-42.5 to -56.5 Vdc)
(See "Power Consumption"
Current Drain" on page
Secondary surge and power cross protection on HDSL2 ports. Requires external
primary protection.
Internal; connected to FUSE ALARM output on pin 25
-40 °F to +149 °F (-40 °C to +65 °C)
5% to 95% (non-condensing)
5.6 in. (14.22 cm)
0.7 in. (1.7 cm)
5.6 in. (14.22 cm)
1 lb., 2 oz. (.51 kg)
200 and 400 mechanics
1.552 Mbps OPTIS
Full duplex
One non-loaded, copper, two-wire cable pair
+16.8 dBm ±0.5 dB at 135 Ω (0-450 kHz) at CO side;
+16.5 dBm ±0.5 dB at 135 Ω (0-350 kHz) at remote side
135 Ω
35 dB at 196 kHz
30 sec. (typical), 1 min. (maximum) per span
100 Ω
1.544 Mbps ±200 bps
Alternate Mark Inversion (AMI) or Bipolar with 8-Zero Substitution (B8ZS)
Extended SuperFrame (ESF), SuperFrame (SF), or Unframed (UNFR)
pk-pk
6 V pre-equalized for 0-655 feet of ABAM cable
+1.5 to -7.5 dB DSX
<400 µs
Meets MTIE T1.101 requirements
0.2 UI maximum
0.1 UI maximum
February 28, 2001
and "Maximum Power Dissipation"
54.)

Appendix A - Specifications

and "Maximum
53