1. Manuals
  2. Brands
  3. ADC Manuals
  4. Control Unit
  5. H2TU-C-202
  6. Quick installation

ADC HiGain H2TU-C-202 Quick Installation

Line unit
Hide thumbs Also See for HiGain H2TU-C-202:
1
2
3
4
5
6
7
Table of Contents

Advertisement

Quick Links

Download this manual
HiGain
HiGain
HiGain
HDSL2
L
1F
H
D
S
L
2
M
O
D
E
STATUS
XMT
D
S
BRG
X
1
RCV
RS-232
DCE
H
2
T
U
•
C
2
0
2
L
B
K
Q
UICK
H2TU-C-202 L
L
U
INE
NIT
I
NSTALLATION
1F
IST

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HiGain H2TU-C-202 and is the answer not in the manual?

Questions and answers

Related Manuals for ADC HiGain H2TU-C-202

Summary of Contents for ADC HiGain H2TU-C-202

  • Page 1 HiGain HiGain UICK NSTALLATION HiGain HDSL2 • STATUS H2TU-C-202 L RS-232...
  • Page 2 H2TU-C-202 L ® The HiGain HDSL2 product family is the industry’s first practical implementation of High-bit-rate Digital Subscriber Line 2 (HDSL2). When an H2TU-C line unit is used ™ in conjunction with a HiGain HDSL2 remote unit (H2TU-R), the system provides 1.552 Mbps transmission on one unconditioned copper pair over the full Carrier Service Area (CSA) range.
  • Page 3 Select the Inventory menu, then type in the unit ID numbers. Change the settings of any system parameters, if necessary, by selecting the Config menu, Standard Options or ADC Options. Once the H2TU-C is successfully installed and provisioned, access the Monitor, Performance, or Event Log menu to clear the Performance, Alarm History, or Event Log screens, or use Master Clear in the Config menu.
  • Page 5 OOPBACK ESTING Initiate loopback testing from the HiGain maintenance terminal screen or use the MODE and LBK buttons. The inband codes below (except COLB, and RULB) can also be sent by a test set. H2TU-R H2TU-C TLOS 1111110 NREM CLOC NLOC CREM 1111100...
  • Page 6 Front Panel Diagnostic Messages Message Description A=xx The loop attenuation of the longest (maximum loss) span, measured in dB. The multiplexers of the HLU and H2TU-R are trying to establish synchronization. Armed to respond to Intelligent Repeater Loop (ILR) codes. BAD RT? The H2TU-C is not receiving a response from the H2TU-R.
  • Page 7 © 2000 ADC DSL Systems, Inc. All rights reserved. Information contained in this document is company private to ADC DSL Systems, Inc., and shall not be modified, used, copied, reproduced or disclosed in whole or in part without the written consent of ADC.

Table of Contents