Troubleshooting - U-Line H-10066 Manual

OPERATING ISSUE
Battery display remains
dark.
User interface and tool
status indicator do
not react.
Tool status indicator
red and pulsating
(stapler blocked).
Tool status indicator
pulsating quickly.
No stapling performed
when actuating trigger.
Skipping staples or
intermittent feed.
Staple jammed in tool.
Slow stapling speed or
blocked.
Poor staple clinch.
PAGE 12 OF 13

TROUBLESHOOTING

CAUSES
Battery faulty/fully discharged.
Inserted battery not permitted
(wrong battery).
Battery not properly inserted.
Sleep mode is activated.
Process sequence warning.
Staple encounters obstacle.
Clamp does not go through carton
(too hard).
Box detection not activated (tool
not on carton).
Magazine not mounted correctly.
Staples out of specification.
Magazine quick release buttons
not locked.
Magazine dirty/debris inside.
Driver blade/clinchers dirty/debris
inside.
Wrong staple size.
Bent staples.
Staples out of specification.
Defective/dirty driver blade.
Battery fully discharged.
Carton too thick.
Wrong leg length setting.
Wrong penetration setting.
Wrong clinch setting.
Driver blade/clinchers dirty/
debris inside.
RECOMMENDATIONS
Charge/replace battery.
Insert correct battery.
Check whether battery is completely
inserted and unlocking device engaged.
Actuate trigger.
Actuate trigger.
Remove jammed staples; see page 10.
Ensure that there are no obstacles.
Only staple common corrugated material.
Place tool on carton.
Install magazine; see page 10.
Replace with recommended staples.
Lock magazine quick release buttons.
Clean magazine.
Clean/replace driver blade and/or clinchers;
see page 11.
Replace with recommended staples.
Clean/replace driver blade and/or
clinchers; see page 11.
Charge/replace battery.
Use other carton thickness.
Adjust staple length; see page 9.
Adjust penetration depth; see page 9.
Adjust staple clinch; see page 9.
Clean/replace driver blade and/or clinchers;
see page 11.
0922 IH-10066