Page 1
H-10066 1-800-295-5510 uline.com KIHLBERG BATTERY-POWERED CARTON STAPLER OVERVIEW OF CONTROLS CONTROL PANEL DESCRIPTION Battery Battery Release Magazine Pusher Magazine with Staple Type Indicator Staples Safety Latch Trigger Magazine Quick Snap System Tool Status Indicator Screw for Staple Length Adjustment Penetration Depth Setting Knob...
Page 2
SAFETY NOTE: These tools are manufactured without • These instructions must always be available at any chemical substances that could be the place of operation of the stapler. They must dangerous to health. Potential health damage be read and observed by all persons working may occur from battery liquid if batteries with, or in the vicinity of, the stapler.
Page 3
SAFETY CONTINUED • Do not abuse the cord. Never use the cord for • Disconnect battery pack from the stapler carrying, pulling or unplugging the stapler. Keep before making any adjustments, changing the cord away from heat, oil, sharp edges or accessories or storing.
SAFETY CONTINUED • Have power tool serviced by a qualified repair • The vibration emission value measured person using only identical replacement parts. may, however, deviate from the specified This will ensure that the safety of the power tool is value depending on the actual application maintained.
SETUP USER INTERFACE FUNCTION Battery Charge Status The stapling tool is positioned on carton to be closed Figure 1 display. (See Figure 1) (box detection sensors activated). (See Figure 3) 2. Mode Indicators: • Actuating the trigger starts the stapling process. MAN, SEMI and AUTO •...
SETUP CONTINUED TRANSPORTING THE STAPLER CHARGING BATTERY To prevent accidental triggering while carrying the tool, WARNING! Only use batteries and charger ensure handle is gripped by hand and index finger is supplied with unit. Use of other batteries or behind the shoulder. (See Figure 4) chargers can result in injury or fire.
SETUP CONTINUED INSERTING/REMOVING BATTERY MAN (MANUAL STAPLING) Individual staples are inserted. A cycle is initiated after Insert the charged battery into the stapler. Insert fully the stapler is placed on the carton and the trigger is until the unlock buttons engage in the stapler. actuated manually.
OPERATION LOADING THE STAPLER OPERATING STAPLER ACTIVATING STAPLER FROM SLEEP MODE NOTE: There is a reloading arrow (1) To avoid unnecessary battery discharge, the tool on both sides of switches to energy-saving mode (sleep mode) after magazine. a short period of inactivity. (See Figure 11) If there are few staples left •...
Page 9
OPERATION CONTINUED CHECKING STAPLE CLINCH ADJUSTING STAPLE LEG LENGTH WARNING! Danger of injury. Never transport The stapler can be adjusted to a 5/8" or 3/4" staple or move packaged goods with improperly leg length. performed stapling. Perform staple check after Remove battery from tool.
MAINTENANCE REMOVING/INSTALLING THE MAGAZINE WARNING! Unintended actuation of trigger and safety latch during maintenance work REMOVING could lead to injuries. Always remove battery before performing cleaning or preventive and Remove battery from stapler. corrective maintenance work. 2. Press quick release buttons (1) on left and right side PREVENTIVE MAINTENANCE SCHEDULE of stapler and pull magazine (2) backward then downward.
TROUBLESHOOTING CONTINUED OPERATING ISSUE CAUSES RECOMMENDATIONS Several staples are set Magazine not mounted correctly. Re-install magazine; see page 10. at once. Staple penetrates Wrong penetration setting (too low). Adjust penetration depth; see page 9. only through upper Staples too short. Replace with longer staples.