Table of Contents
Advertisement
How to Connect a C-Nav3050 to the
C-NaviGator III
For this setup configure as below:
Both Receiver and Controller now should have IP address with which they can
communicate. To setup this communication at the C-NaviGator III end follow the
below:
1. Navigate to the following options menu:
Menu / Settings / Network Virtual Ports
2. Press New.
3. Under the Network Virtual Ports configure the settings outlined below
and select "Apply" from the right hand menu.
Revision 3
Page 18 of 31
4/13/2017
Advertisement
Table of Contents
Need help?
Do you have a question about the C-Nav3050 and is the answer not in the manual?