Table of Contents
Advertisement
How to Connect a C-Nav3050 to the
C-NaviGator III
In this configuration the receiver we will use the factory default IP address and
Netmask of:
IP: 192.168.0.2,
Netmask: 255.255.255.0
1. Navigate to the following options menu:
Menu / Port X 3050 / Next / Ethernet Settings
Configure the setup as below:
The Ethernet virtual port, is enabled by selecting the port then pressing
Revision 3
Page 17 of 31
4/13/2017
Advertisement
Table of Contents
Need help?
Do you have a question about the C-Nav3050 and is the answer not in the manual?