Direct Ethernet Connection - Oceaneering C-Nav3050 Manual

How to Connect a C-Nav3050 to the
C-NaviGator III

Direct Ethernet Connection

Perform the following steps to configure the receiver for a Direct Ethernet
connection:
1. Connect to the C-Nav3050
USB or a serial COM port, this is required temporally while the settings are
correctly entered.
2. Navigate to the following options menu:
Menu / Settings / System Network Settings
3. Under the System Network Settings configure the settings outlined below
and select "Apply" from the right hand menu.
Revision 3
®
GNSS receiver on an available port, such as
Page 16 of 31 4/13/2017