Panel Installation - EAS Electric ECMV2 Series Owners And Installation Manual

Panel Installation

CAUTION
DO NOT place the panel facedown
on the floor, against a wall, or on
uneven surfaces.
(A)
Super-Slim models
Step 1: Remove the front grille.
Push both of the tabs towards the
1.
middle simultaneously to unlock
the hook on the grille.
Hold the grille at a 45° angle, lift it
2.
up slightly and detach it from the
main body.
Step 2: Remove the installation covers at
the four corners by sliding them
outwards.
Step 3: Install the panel
Align the front panel to the main body,
taking into account the position of the
piping and drain sides. Hang the four
latches of the decorative panel to the
hooks of the indoor unit. Tighten the
panel hook screws evenly at the four
corners.
NOTE: Tighten the screws until the
thickness of the sponge between
the main body and the panel redu-
ces to 4-6mm (0.2-0.3"). The edge of
the panel should be in contact with
the ceiling well.
Adjust the panel by turning it to the
arrowed direction so that the ceiling
opening is completely covered.
Piping side
Drain side
Screwdriver
1. Connect the two louver motor
connectors to
wires in the control box.
Control box
Connect the
louver motor
41
Latch
the corresponding
Connect the
louver motor
V.2