EAS Electric ECMV2 Series Owners And Installation Manual page 90

Step 3: Install the panel
Align the front panel to the main
body, taking into account the position
of the piping and drain sides. Hang
the four latches of the decorative
panel to the hooks of the indoor unit.
Tighten the panel hook screws evenly
at the four corners.
NOTE: Tighten the screws until the
thickness of the sponge between the
main body and the panel reduces to
4-6mm (0.2-0.3"). The edge of the
panel should be in contact with the
ceiling well.
Adjust the panel by turning it to the
arrowed direction so that the ceiling
opening is completely covered.
Drainage interface
louver motor
Main body
Ceiling
Panel side
sponge
Panel
Panel foam 1
Out of the wind
Piping interface
Into the wind
Outlet foam
Panel foam 2
Baffle
NOTE: If the height of the indoor
unit needs to be adjusted, you can
do so through the openings at the
panel's four corners. Make sure that
the internal wiring and drainpipe
are not affected by this adjustment.
Water condensation
CAUTION
Failure to tighten screws can cause
water leakage.
Gap not allowed
CAUTION
If the unit is not hung correctly and a
gap exists, the unit's height must be
adjusted to ensure proper function.
The unit's height can be adjusted by
loosening the upper nut, and adjus-
ting the lower nut.
44
1 Loosen upper
nut
2 Adjust lower
nut
V.2