Valve Box Installation; Figure 11 - Valve Box Wiring Diagram; Table 5 - Cable Wires - Rain Bird ISDL-2400 Installation, Programming & Operation Manual

Valve Box Installation

To install the valve boxes:
At each valve box, locate and identify the wire
path and the sensor cable as shown in Figure 11.
Use a wire cutter to cut the wire path, and insert
the two ends of the wire path and the end of the
sensor cable into the valve box.
Using a wire stripper and Rain Bird DB-series
wire connectors, connect the sensor cable to the
wire path as shown.

Table 5 - Cable Wires

Cable Data
Wire Path Green
TSM-3 (Type 3) Blue
Replace the soil and turf carefully around the
valve box so that after a short healing period the
installation is no longer visible.
76 Integrated Sensor System
Connect
Ground Wires
Connect
Data Wires
Power Ground
Red White
Red Black
Valve Box
Trench
Wire Path

Figure 11 - Valve Box Wiring Diagram

Connect
Power Wires
Rain Bird DB
Wire Connector
Sensor
Cable
Trench