Wire Path Installation; Figure 10 - Wire Path Installation - Rain Bird ISDL-2400 Installation, Programming & Operation Manual

Wire Path Installation

To Install the Wire Path:
Using a spade, sod cutter with blade mole kit, or a
vibratory plough, lay cable around the green deep
enough to avoid damage from aerifi cation as shown
in Figure 14. Start at either the data logger or the
furthest valve box location.
Set the wire into the trench if pulling, leaving enough
extra wire to make the data logger and valve box
connections.
Replace the soil and turf carefully over the trenches so
that after a short healing period the installation is no
longer visible.
ISDL-2400
Auto
SENSOR
BASIC
OFF
CONFIGURE
SPECIAL
DATA
FEATURES
LOGGER
SD
CARD SENSOR
INFO SETUP
SYSTEM
SENSOR BACK-LIGHT
RESET
RADIO
ISDL-2400
Wireless Data Logger
Manual
Wire Path

Figure 10 - Wire Path Installation

Integrated Sensor System 75