Query Sensor (Ch 1 Or Ch 2) - Rain Bird ISDL-2400 Installation, Programming & Operation Manual

Query Sensor (Ch 1 or Ch 2)

This function provides the address
of one individual sensor connected
to the selected channel, and can
reset the address of the sensor to 0.
If more than one sensor is connected
to the channel, no addresses will be
displayed.
Turn the dial to
SENSOR SETUP
The Sensor Setup screen
appears. Press the UP or DOWN
button to select Query Ch 1 (or
Ch 2); then press OK.
The Query Channel 1 (or 2) screen
appears and "Only one sensor can
be connected... " is displayed.
"Scanning" is displayed while
performing the query.
NOTE: If no sensor is found, the
"No sensor detected" message is
displayed.
When completed, the "Found
sensor [#]" message displays the
address of the sensor.
Press RETRY to run the Query
again if desired.
NOTE: The RESET button
can be pressed to change the
sensor address back to "0". This
should always be pressed when
installing a new sensor on the
ISDL to verify the address is 0.
When fi nished, turn the dial
to Auto (SENSOR or BASIC)
Integrated Sensor System 21