Job No. - Olet (Ole System Test) - Promax RR 14 EVO 2 400 Hybrid Operating & Maintenance Manual

PAMP020RR
Revision 2
December 2019
Job No. – OLET (OLE system test)
Scheduled work
1 With machine on level rail
Check OLE interlock key is present and in 'normal'
2
mode
Check boom functions for operation (all functions
3
should operate normally
4 Turn OLE switch to 'OLE working mode' position
Check boom functions for operation (all boom
functions should be inactive except:
5 - Turret rotate
- Upper boom may raise slightly
- Fly jib will raise cage to pre-set position
Lower upper boom fully and fly-jib to position
6
cage just above rail head.
Using all functions, attempt to raise cage to
7
highest possible position
Measure from rail head to cage floor, distance
8
should not exceed 1400mm
Lower all booms to position cage just above rail
9
head
1
Turn OLE lock valve into 'locked' position
0
1 Check boom functions again – no boom functions
1 should operate
1 Return OLE valve and key switch to 'normal'
2 operating position
RR 14 EVO 2 400 Hybrid
Arising work
2 Replace missing key
2 Switch to 'normal' mode
3 Check OLE switch position
5 Check OLE switch operation
5 Renew any missing/damage parts
8 Adjust OLE sensor on fly-jib
8 Re-test from (6)
1
Renew any missing/damage parts
1
Revision Record
Page 60 of 73