Section 8; Alo Working Procedure - Promax RR 14 EVO 2 400 Hybrid Operating & Maintenance Manual

PAMP020RR Revision Record
Revision 2 Page 47 of 73
December 2019 RR 14 EVO 2 400 Hybrid

Section 8

ALO Working procedure

1. Identify open line
2. Approach RRAP ensuring machine is oriented correctly
3. Slew turret to safe side
4. Inspect pin for damage etc, replace if damaged or bent (machine is equipped with 2 pins
in case of loss or damage)
5. Insert pin in correct hole – Note: with turret slewed to safe side, pin will not fully engage in wrong hole
6. Check ALO lockout area on display is shown
7. Slew against ALO slew lock pin to ensure correct insertion
8. Close canopy
9. Lock canopy with padlock to avoid tampering