Section 2; Introduction - Promax RR 14 EVO 2 400 Hybrid Operating & Maintenance Manual

PAMP020RR Revision Record
Revision 2 Page 9 of 73
December 2019 RR 14 EVO 2 400 Hybrid

Section 2

Introduction

The Promax RR 14 EVO 2-400 Hybrid is designed to operate in a railway or construction environment to
facilitate the lifting of persons and associated tools - A maximum of three personnel plus tools and equipment
(400kgs combined) may be carried in the platform on rail to maximum 200 mm cant and at maximum 1:16
gradient.
See page 30, sect '3' Technical Specification of Platform Basket Use & Maintenance Manual, Logbook code:
4528576300.0, Edition 11/2019 for height and reach etc and/or working diagrams attached to machine.
The machine is designed and built to be able to on and off track at any designated RRAP.
This machine is suitable for use under the live OLE when used in conjunction with a safe system of work
determined and authorised in accordance with the requirements of GE/RT8024
With the Platform fully stowed (telescope fully retracted, main boom down and turret inline /in-gauge the RR
14 EVO will travel at maximum allowable rail speed for this class of RRV.
MEWPs are not intended for use as cranes and must not be used for lifting or suspending loads other than
persons and small tools, wire pulling etc.
The RR 14 EVO is able to travel in working mode while elevated or slewed out of the stowed position
(telescopic boom fully retracted) while maintaining floating / oscillating axle -whilst the MEWP is travelling with
the boom in an un-stowed configuration, the machine is to proceed at walking speed and ground staff control
the movement in reverse until the superstructure can be slewed to face direction of travel.
Emergency stopping devices shall not be used for stopping normally and should only be used in emergency
situations. Activation of an emergency stop button will turn off all electrical power to the machine (including all
machine lighting), de-energise the engine fuel valve (which should shut down the engine) and disable all
controls of the machine.
This RRV has electrical / electronic equipment sited at various locations around the vehicle including chassis
and railgear. Electrical equipment such as sockets and modules cannot be totally sealed against against
water ingress during immersion or high pressure washing.
Do Not operate the RRV with the wheels in water above the hub/axle level.
Do Not direct high pressure water onto switches, sensors, slip rings, plugs, sockets, panels or electronic
modules.
Limitations as per engineering conformance certificate.
This manual should be read in conjunction with the following documents:
Platform Basket Use & Maintenance Manual, Logbook code: 4528576300.0, Edition 11/2019.
Platform Basket Appendix of the Use & Maintenance Manual (Lithium Batteries Version RR), Logbook code:
4528575300.0, Version 08/2019.
BEFORE OPERATING, MAINTAINING or LOADING / UNLOADING ENSURE YOU ARE FULLY FAMILIAR WITH ITS
CORRECT OPERATION AND FULLY UNDERSTOOD THE OPERATING MANUAL. FAILURE TO DO SO MAY RESULT IN
DEATH OR SERIOUS INJURY.