Table of Contents
Advertisement
PAMP020RR
Revision 2
December 2019
Definitions
Term
Action required
Adjust
Correct to defined limits
Change
Remove the original and fit a new or overhauled part or assembly in its place
Check
Determine a particular nominated condition before, during, or after repair, for example
completeness, security, position
Clean
Remove all dirt and deposits
Defective
Any fault or faults in a component or assembly, for example structural fractures or weld
fractures, which may prevent the component or assembly from fulfilling its designed
purpose
Dismantle
Take to pieces
Examine
Determine general condition before repair, for example wear, cracks, splits, leaks, scoring,
erosion, breaks, distortion, looseness
Gauge
Determine a nominated dimension by using suitable measuring equipment, for example
ruler, micrometer, callipers, feeler gauges or Go / No-Go gauge
Inspect
Determine general condition after repair and attention, that is to say, conformity to
required standards
Lubricate
Apply lubricant
Overhaul
Do what is necessary to make an assembly or sub-assembly reusable, that is to say,
dismantle, strip, clean, examine, fit new parts, repair, reassemble, test and inspect, as
required
Paint
To impart colour to a surface
Re-assemble
Put together
Record
Put down in writing a finding from examination, test, inspection or special checks
Rectify
To set right
Refit
Put back and reconnect
Remove
Disconnect and take off
Renew
Remove, scrap the original part and put a new part in its place
Repair
Restore an original part to the required condition by hand tooling, machining, build-up,
welding, patching, bending, setting, heat-treating, re-securing etc
Strip
Remove covering, that is to say, paint, polish, fabric
Test
Prove correct operation by trial
RR 14 EVO 2 400 Hybrid
Revision Record
Page 8 of 73
Advertisement
Table of Contents
