Installation - Kohler 22327T-7 Installation Instructions Manual

Dual shower set
Table of Contents

Advertisement

INSTALLATION

Electrical Outlet
Adaptor
Cable 10m
Remote Control
Cable 1m
Outlet1
Drip Loop
(Showerhead)
Drip Loop
Outlet 2
(Handshower)
Cable 10m
Inlet(Cold)
Joining Cable
Inlet(Hot)
Min R40
Port A
Min Ø25
Port B
Cable Tube
Vertical
Horizontal
3
Electrical Outlet
1
Inlet(Cold)
Inlet(Hot)
2
Connector Kit
Outlet1
Outlet 2
Nut A
(Showerhead)
(Handshower)
Ring
Nut B
1354659-2A-C
Preparation
NOTES: Make sure both hot and cold supply pipes
are flushed thoroughly prior to connection to the
Digital Mixer Valve.
If possible, install electrical outlet before installing the
valve. Please turn off the electrical and water supplies
before installation. Always keep the valve and outlet
dry. Allow for enough slack in the cables for drip
Dual Shower
loops.
UI
Remote Control can be installed outside showering
enclosure, while the Dual Shower Interface is inside
the showering enclosure. Determine all required
components along with their installation locations
before beginning installation. NOTES: The valve can
not be connected to two interfaces at the same time.
When routing pipes, keep in mind each valve outlet
must correspond to the appropriate showering compo-
nent for the preprogrammed or custom showering
experiences to function properly. Please prepare
cable tubes before routing cables as the dimension.
NOTES: The showerhead fill supply line must be
routed from outlet 1, and the handshower is from
outlet 2. Port A is for the dongle(not provided, 23777T)
connection, port B is for joining cable.
Install the Valve
NOTES:
The Digital Mixer Valve may be installed in a
loft space or in a convenient space provided enough
room for maintenance. Failure to do so may result in
an inability to carry out any maintenance.
Installation Direction of the Valve
Do not mount the valve with the inlets located at the
top.
Do not
mount the valve with the inlets or cable
sockets pointing up.Vertical and horizontal mounting
options are shown as the figure.
Installation Steps
□ Mark the fixing holes in required positions,drill three
holes on mounting surface according to the rough-in
dimensions and diameter of the anchors(2).
□ Press anchors into the holes, install and secure
Digital Mixer Valve in position with fixing screws(1).
NOTES: Install the offset foot(3) if needed.
□ Install nut A, the ring and nut B onto inlet/outlet.
Hand-tighten nut A and nut B. Hold nut A with a
wrench, meanwhile tighten nut B with another wrench.
NOTES: The connector kit must be pushed into the
end towards valve direction,tighten it firmly.
□ Connect hot and cold water supply pipes to Digital
Mixer Valve.
□ Route pipes from valve outlet to the installation
locations of showerhead and wall-mount connection.
□ Route cables from valve to the Dual Shower UI and
Remote Control installation locations.
Statistics of Contents of Toxic or Hazardous Substances or Elements
Part name
Valve
Interface Assy
Connection Assy
Faucet Assy
○:Indicates that the substance in the material composition is below the high limits of the current requirements in
GB/T 26572.
×:Indicates that at least one of the homogeneous substance in the material composition is above the high limits
of the current requirements in GB/T 26572.
Note: the information provided is based on the supplier data and Kohler inspection results. The product is
designed not to hurt the environment. Under current technology, all hazardous materials have been used in the
smallest amounts possible. Kohler will strive to reduce the use of these hazardous materials used in this product.
The product "service life for environment protection" is 10 years; Kohler Company will specify product
service life based on product characteristics. The product "service life for environment protection" is only
effective when the product is used as described in the product specification.
4
1354659-2A-C
Toxic or Hazardous Substance or Elements
Hexavalent
Lead
Mercury
Cadmium
Chromium
(Pb)
(Hg)
(Cd)
(Cr(VI))
×
×
×
×
Polybrominated
Polybrominated
biphenyls
Diphenyl Ethers
(PBB)
(PBDE)
13

Advertisement

Table of Contents
loading

Table of Contents