Global Output Commands - Delta D750 User Manual

User Manual
D750
DC Power Supply
3 OUTPut:PON<SP><value>
4 OUTPut:PON?
5 SYSTem:VERSion?
6 SYSTem:DATE?
5.COMMON COMMANDS
1 *IDN?
2 *SAV<SP><0>
3 *RCL<SP><0>

4.2.7.7 Global output commands

1. General
All supplies, even if not the currently addressed supply, receiving a global command
will execute the command. No response to the PC issuing the command will be
returned to the PC. The PC issuing the command will be responsible to delay and any
other communications until the command is execute. 200ms minimum is the suggested
delay.
If the command contains an error, out of range values for example, no error report will
be sent to the issuing PC.
1. GRST
2. GPV n
3. GPC n
4. GOUT
5. GSAV
6. GRCL
66 │ www.deltaww.com
Reset. Brings the Power Supply to a safe and known state:
Output voltage: 0V, output current: 0A, OUT: Off, Remote: RMT 1'
AST: Off OVP: Max,
Non-Latching faults (FB, OVP, SO) are cleared, OUT fault stays.
Sets the output voltage value in volts. The range of voltage values is
shown in Table 4-8.
Program the output current value in amperes. The range of current values
is shown in Table 4-9.
Turns the output to ON or OFF:
"OUT 1/ON" = turn on
"OUT 0/OFF"= turn off
OUT ON will respond with "E07' if the output cannot be turned on
because of a latching fault (OTP< AC, ENA, SO) shutdown.
Save present settings. Same settings as power-down last settings listed
in Sec. 3.3. Except the address and Baud rate are not saved Saves to the
RAM. These settings are erased when the supply power is switched off
and the new 'last settings' are saved.
Recall last settings. Settings are from last power-down or from last 'SAV'
or 'GSAV' command. Address and Baud rate are not recalled so
communication is not Interrupted.
W SET POWER SUPPLY POWER-UP
MODE COMMAND
R REPORT POWER SUPPLY POWER-UP
MODE COMMAND
R READ SCPI VERSION COMMAND
R READ DATE COMMAND
R READ IDENTITY COMMAND
W SAVE POWER SUPPLY SETTINGS
COMMAND
W RECALL POWER SUPPLY SETTINGS
COMMAND
UVL:0.