Enable Changeover Group - Mitsubishi Electric PAC-WHS01WF-E Technician Manual

Back
Living Room
Enable A uto Mod e to
switch between heat and
cool?
Yes
4
No
Home
4. Select Yes to enable the Auto mode. Enabling Auto Mode allows the new unit to regulate its heating
and cooling without the direct interaction of the user. The unit will be able to operate automatically within
a range of selected temperature values. Tap Next.

Enable Changeover Group

Determine whether this unit should be grouped with other units in the user's home.
5. Select Yes to add this zone to a system changeover group. A Changeover group can be used to
coordinate the heating and cooling demands of indoor units connected to the same outdoor unit. This
feature, specific to some MXZ systems, allows kumo cloud
based on the conditions and priorities of zones within the same changeover group. If you tap No, the
zone will operate independently. Skip to Finish Setup. See the
6. Choose if you would like to add this site to an existing Changeover Group or create a new
Changeover Group that includes this site.
7. Tap Next. If you have chosen to select an existing group, skip to Step 10 below.
8. Select input field and input desired Group Name.
Tap Create Group to proceed.
9.
10. Here, the recently created/desired Changeover Group is displayed as selected. Confirm this selection.
11. Tap Next to continue.
© 2021 Mitsubishi Electric US, Inc.
Connect Cancel
5
NEXT
Program Settings
Cancel
Connect
Home
8
Group Name
CREATE GROUP
Home Program Settings
Back
Connect Cancel
Add this zone to a system
changeover group?
Yes
No
NEXT
Home Program Settings
® to manage the mode of the outdoor unit
Finish Setup
Connect
Home
70°
10
Office 1st Floor
70°
9
Office 1st Floor
NEXT
Home Program
Back Connect
Cancel
Select existing group or
create a new group?
Select Existing Group
6
Create New Group
7
NEXT
Home Program Settings
section. Tap Next.
Cancel
70° OFF
2nd Floor
70° OFF
2nd Floor
11
Settings
Specifications are subject to change without notice.
9