Add Wireless Sensor - Mitsubishi Electric PAC-WHS01WF-E Technician Manual

Add Wireless Sensor

Accessory
Back
Add Wireless Sensor
+
Add Backup Heater
+
Add Humidifier
+
Add Dehumidifier
+
Add Ventilation
+
Add Hydronic Heater
+
Home Program
The PAC-USWHS003-TH-1 Mitsubishi Electric Wireless Temperature and Humidity Sensor is a wireless
sensor that is designed to provide remote sensing capabilities to the Wireless Interface. This is an optional
part. One Wireless Sensor may be configured for each Wireless Interface.
Note: We recommend that each sensor be commissioned to kumo cloud
surface. This will ease set up.
1. Tap Add Wireless Sensor.
Wait for kumo cloud to locate your Wireless Temperature and Humidity Sensor device. View devices
2.
located and tap the appropriate sensor to connect. Be sure the smartphone/tablet is within close
proximity to the sensor while searching. If the sensor cannot be located, try putting it into discovery
mode again and repeating the search. To put the Wireless Sensor into discovery mode, after the battery
insulation sleeve has been removed, knock on the sensor case or drop the sensor onto a table surface
from about 4" high until you hear the series of beeps or chirps.
3. Choose the Zone that the remote sensor should control (i.e. living room, kitchen, etc.).
Tap Save to continue back to advanced site settings.
4.
To check Sensor battery life or battery replacement, refer to the Owner Manual at
Additional Resources.
Note: It is recommended that you commission the Wireless Sensor before adhering it to a wall.
© 2021 Mitsubishi Electric US, Inc.
Back
1
1 new temperature/
humidity sensors found
Connect
Very strong signal
For stronger signal, move
closer to the unit(s).
Settings Home
Cancel
Sensor
75° 54%
2
Program Settings
®
Sensor
Back
To which wireless interface
should the sensor connect?
Living room
3
SAVE
4
Home Program Settings
BEFORE affixing to a wall or other
kumocloud.com
Specifications are subject to change without notice.
under
19