Firmware; Terms And Definitions - Mitsubishi Electric PAC-WHS01WF-E Technician Manual

Firmware

To check the firmware running on the Wireless Interface, follow the steps in the
and note the firmware number. Firmware updates load automatically.

Terms and Definitions

Min Cool Set Point
Max Heat Set Point
Thermal Off Fan
Humidifier
Electric Heater Kit
Heater in Defrost
Static Pressure
System Type
Dehumidify/Dry
Optimal Start
Restart After Outage
Ventilation Air
Power Voltage
Auto Energy-save
Filter Alerts
Auto Fan
Filter Type
PLA Air Outlets
Frost Temperature
Defrost Control
PLA Airflow Oscillate
Heating Offset
Refresh Settings
Settings by Number
© 2021 Mitsubishi Electric US, Inc.
61°–88° F (Varies by indoor unit)
61°–88° F (Varies by indoor unit)
Set the fan operation for Thermal Off, when the set temp has been met:
Extra Low in Heat, Stop in Heat, Stop in
Cool and Heat, Stop in Cool, or Selectable in Cool and Heat
When do the unit fan and humidifier run?
How should the Electric Heater Kit operate? Comfort Mode,
Economy Mode, or Basic/Single-stage Mode
Should the backup heater run while the indoor unit is in
defrost or error?
See the Airflow for Static Pressure
Cool only, or Cool and Heat
Enable Dehumidify/Dry mode?
Enable Optimal Start to start heating or cooling early to
reach a programmed setting?
Automatically restart unit after a power outage?
Intake outdoor air through LOSSNAY?
230V or 208V
Enable auto energy-savings operation?
How often should filter alerts display?
Auto fan speed setting: Quiet, Standard or High Ceiling
100 hours or 2500 hours
How many air outlets are being used?
Indoor Unit Frost Prevention Temperature: 36 or 37° F
Standard or High Humidity
Enable Airflow Oscillate mode so that each vane on a PLA
unit moves independently?
Enable Heating Mode Temperature Offset?
If Installer Settings have been changed via another
controller, the new settings won't show in kumo cloud until
refreshed. Turns the unit off temporarily.
Add a setting using the number code provided in an app
note or another manual.
Access Unit Settings
section
Specifications are subject to change without notice.
section
35