Kumo Station; Add Kumo Station Accessory - Mitsubishi Electric PAC-WHS01WF-E Technician Manual

®

kumo station

The PAC-WHS01HC-E, Mitsubishi Electric Equipment Controller, kumo station contains relays that allow
for controls integration of third-party backup heaters, humidifiers, dehumidifiers, ventilation systems, and
hydronic heaters. kumo station may be optionally wired to an indoor unit. If you choose this configuration, set
up the indoor unit zone via kumo cloud before adding any kumo station accessories.
Note: Each kumo cloud Site can be associated with up to 1 kumo station. Multiple kumo stations can be
supported within an account by adding a separate Site for each kumo station.
Alternative Setup
Note: If attempting to set up a kumo station that is not directly connected to an indoor unit, follow these steps.
Refer to the Equipment Controller Manual (kumo station) for diagrams.
1. Remove kumo station cover.
2. Search for the SW1 switchboard. This is a very small group of switches in the middle of the device if
viewed vertically. This switchboard is labeled from #1-8.
3. Please switch the #5 toggle of SW1 to the "on" position, then press and hold the button nearest the
LEDs on the Wireless Interface for 5 seconds followed by quickly releasing it. Wait for the Wireless
Interface's blue LED lights to begin flashing quickly in groups of 4.
4. Once this state is reached, repeat the commissioning process for a kumo station that is not directly
connected to an indoor unit in order to connect Accessories (i.e. humidifiers,dehumidifiers etc.)
Note: For the system to function properly, the kumo station that is not connected to an indoor unit must be
the final wireless interface to be provisioned.

Add kumo station Accessory

Accessory
Back
1
Add Wireless Sensor
+
Add Backup Heater
+
Add Humidifier
+
Add Dehumidifier
+
Add Ventilation
+
Add Hydronic Heater
+
Home Program Settings
Third-party backup heaters, humidifiers, dehumidifiers, ventilation systems, and hydronic heaters can be
managed within kumo cloud by adding them as kumo station accessories. As many as 4 accessories can be
added to each kumo station.
To add a kumo station Accessory, first, install kumo station and accessories per PAC-WHS01HC-E Equipment
Controller (kumo station) installation manual (included with kumo station).
Then, from your kumo cloud app:
1. Tap Add (choose your preferred Accessory type).
2. Wait for the kumo station Accessory to be discovered. Select an accessory. If the kumo station
accessory is connected to an indoor unit, the zone name will be displayed. If the kumo station
accessory is not connected to an indoor unit, select the appropriate Wireless Interface from the list.
Provide a name to identify the kumo station accessory and tap Next.
3.
Select the Channel to which the accessory is physically wired within kumo station. Tap Next.
4.
© 2021 Mitsubishi Electric US, Inc.
1 new wireless interfaces
found. To which is the
heater wired?
Connect 2 2
Strong signal
For stronger signal, move
closer to the unit(s).
Home Program
Heater
In what location is ..BF:82:F5?
Wireless interface name
3 3
NEXT
Home Program
Settings
Specifications are subject to change without notice.
Heater Cancel
Outside air temperature: None
How is the heater wired to
the kumo station®?
4
Channel 1
Channel 2
Channel 3
Channel 4
NEXT
Home Program
Settings
21