Connect A New Site; Find Installer Settings - Mitsubishi Electric PAC-WHS01WF-E Technician Manual

Note: If you are connecting an MHK1 or an MHK2, ensure that you configure the WI 2 with the kumo cloud
app as follows before you connect the interface to the controller.
1. Four quick, blue flashes indicate Bluetooth LE configuration mode. The interface is ready to connect
using the app. Three slow, blue flashes repeat after Connection is complete.
2. The green light glows when power is connected. No further hands-on work with the interface is needed.
It will change to wireless network mode to automatically check for firmware updates during set up.
3. If needed, use the configuration button to switch from the wireless network mode back to the
Bluetooth LE configuration mode. Push, hold 5 seconds and release.
4. In special cases, technical support may suggest a factory reset. Push and hold the factory reset button
until the amber LED turns on (about 5 seconds), then release in order to revert to factory firmware. In
order to revert to factory firmware and erase all user settings, push and hold the factory reset button.
Wait until the amber LED turns on and then begins to blink (about 8 seconds), then release the button.
If using first generation Wireless Interfaces (PAC-WHS01WF-E), skip to
Interfaces. Otherwise, continue below.

Connect a New Site

● The Wireless Interface 1 and 2 must connect to a 2.4 GHz Wi-Fi
● The Wireless Interface 1 and 2 will not work on a 5 GHz Wi-Fi network.
○ The Wireless Interface 1 and 2 can only connect to Wi-Fi channels 1-11.
● For the best performance connect the Wireless Interface 1 and 2 to a 2.4 GHz only SSID, but there are
some multi-band Wi-Fi networks that can correctly manage a 2.4 GHz only device.
○ Please verify if your multi-band Wi-Fi router can manage 2.4 GHz only devices.
Note: The set up of the Wireless Interface to the kumo cloud app requires a Wi-Fi network with a live internet
connection.
Before connecting a new site, make sure the smartphone or tablet has Wi-Fi and Bluetooth turned on, and a
working 2.4 GHz wireless internet connection. Connecting a New Site and Adding Indoor Units must be done
on site. Transfer to Owner and setting Advanced Settings may be done remotely.

Find Installer Settings

Home
No equipment is connected.
Ask your professional installer
to complete setup.
GET HELP
Home
1. Tap Settings.
Tap System Setup.
2.
3. Tap Installer Settings.
Specifications are subject to change without notice.
6
ATTENTION
Zones
My Account
Filters:
Help:
System Setup
Legal
Program
Settings
1
®
network.
Settings
Dirty in 2 zones
2 errors
2
Home Program Settings
First Generation Wireless
Settings Setup
Edit
Units: Fahrenheit
Lock to single zone
Wi-Fi: P P r r o o b b l l e e m m
IFTTT
Transfer Ownership
3
Installer Settings
Home Program Settings
© 2021 Mitsubishi Electric US, Inc.
®