I-O Corporation Series; I-O Corporation 1181D; I-O Corporation 1181Ep; I-O Corporation 1181Es - Intermec MicroBar 9710 Reference Manual

C d 39

I-O Corporation Series

I-O Corporation Series
This section covers these workstations:
The individual Wedge Interface Guide corresponding to this section is part number
055873.
Cables
Connecting the reader to one of these workstations requires two cables: a keyboard
cable and a terminal cable. The interface kit contains both the keyboard and terminal
cables. If you need to order a replacement cable, use the part numbers listed below:
Power Supply
The reader does not require an external power supply to work with the workstation.
Even though the reader does not require a power supply, set the PCB jumper to connect
pins 2 and 3 on the reader's rear panel. This is an exception for the I-O Corporation
workstations.
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User's Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
I-O Corporation
83-key Keyboard
56
•

I-O Corporation 1181D

•

I-O Corporation 1181EP

•

I-O Corporation 1181ES

•

I-O Corporation 1181WP

•

I-O Corporation 1196

•

I-O Corporation 1196D

•
Wedge interface kit (P/N 055872)
•
Keyboard cable (P/N 055871)
•
Terminal cable (P/N 055870)
•

I-O Corporation 1197

•

I-O Corporation 2196

•

I-O Corporation 2476C

•

I-O Corporation 2497C

•

I-O Corporation 2497D

Scan This Bar Code
*$+TA321*
*$+TA321*