Power Supply
The reader requires an external power supply to work with these workstations. Set the
PCB jumper to connect pins 2 and 3 on the reader's rear panel.
•
HP X-Station 700/RX
•
NCD X-Station 15-b
•
DEC VT520
•
DEC VT525
Note: If you use an external power supply for the reader, you must plug in the power
supply before switching on the workstation. If you do not, the reader may lock up.
If you have a different workstation other than these, the reader does not require an
external power supply to operate. Set the PCB jumper to connect pins 1 and 2 on the
reader's rear panel.
Caps Lock Sensing
The Caps Lock Sensing feature allows the reader to sense if the workstation keyboard
has Caps Lock enabled or disabled. The reader can then transmit the characters from
scanned labels to the workstation in the same case as they are printed on the label.
Scan this label to enable Caps Lock Sensing:
*$+WC1*
*$+WC1*
Scan this label to disable Caps Lock Sensing:
*$+WC0*
*$+WC0*
By default, Caps Lock Sensing is disabled.
C d 39
PC/AT, PS/2 Universal
71