2.4.2
Wall-Mounting the Phone
You can mount the phone on a wall or wall plate. You need two screws (not supplied) to fit the
keyhole slots.
To wall mount the phone:
1.
On the wall or a wall plate, drill two holes with a distance of 3 15/16 inches (100 mm) apart.
2.
Thread a screw into each hole with each head extending about 3/16 inch (5 mm) from the
wall or wall plate.
3.
Connect the AC power adapter, LAN and PC cords and route them to go under the bracket.
4.
Adjust the phone bracket so that it lays flat on the back of the phone (as described in Section
2.4.1.1
User's Manual
Figure 2-7: Wall-Mounting Dimensions
on page 16), and then secure it in position using the supplied screws.
Figure 2-8: Securing Phone Bracket to Base of Phone
18
320HD IP Phone
Document #: LTRT-24503